CineTank MK 2 L

  • Product Code: 10032
  • Sku: 10032
  • Availability: In Stock
  • $174.00

Available Options

CineTank MK2 features include: 

  • New open bottom dirty plate (gives you faster and easier access to your electronics)
  • New X brace top dirty plate
  • New placement for silicon dampers, 3 on each corner, 2 additional on front and back
  • Total of 16 silicon dampers to allow tuning for different conditions and weights
  • Additional space between silicon dampers
  • Optional hole patterns for Flight controls and PDB
  • New side plate design with Flying Cinema logo
  • Optional Flight control/ PDB screw holes on dirty section.
  • New side plates with FlyingCinema logo
  • Removable bottom access hatch with provisions for 500 size heli landing gear
  • New plastic mount molded parts
  • New clean section, extended 10 mm forward to better support 12 inch props and gimbal
  • 6 new slots for velcro straps, 2 horizontal and 4 vertical
  • Additional side plate indents for screw clearance
  • Optional standoff placements for additional reinforcement
  • Overall weight of complete frame reduced by 24gr
  • New gimbal adapter slots
  • New dipole UHF antenna place holder
  • New SMA antenna socket

  • Original Features: 

  • 514 mm diagonal Motor-to-motor.
  • 8 and 12" props max.
  • Jello Free.
  • No props in view even with GoPro Wide settings.
  • Carbon Fiber Arms that provide better aerodynamics and vibration dampening.
  • G10 frame with honeycomb design to add strength and drastically reduce weight, also RF transparent for better range.
  • All hardware is hex M3 stainless steel, only one tool needed to assemble the frame.
  • Wera hex driver included with every frame kit.
  • Flight controller mounting holes to support cc3d, Revo, Naze32, KK2, ArduPilot, etc.
  • Motor Mounts support inverted motors for X8-Octocopter layout.
  • The dirty section (bottom) has walls to increase strength and torsional rigidity of the copter and also protects your ESCs and other electronics.
  • Camera plate adjust fore and aft to change CoG and help you balance your craft.
  • Wires from motors can be routed via the carbon fiber tubes to protect them in the event of a crash.
  • The motor mounts are designed to protect the motors and the motor wires in the event of a crash.
  • Low profile landing gear pads.
  • The quad frame is manufactured in-house in the USA!

  • SunnySky V3508 750kv, 580kv, 380kv or Tiger MN3508 750kv, 580kv, 380kv
  • 4s and 6s configurations (4000mha 4S - 5000mha 4S) 

  • Original Features: 

  • Documents 

  • PID Settings

  • Recommended Power System-

Write a review

Note: HTML is not translated!
    Bad           Good

Related Products